They were inadvertently relying on undefined behavior in C and we get
different results on some compilers.
Until we decide how we want the operation to behave, for now, just
leave it unspecified.
The current behavior is undefined in C when converting the double to a
u32, so the tests fail on some compilers. For now, I'm just removing
those parts of the tests because I'm not sure what I want the behavior
to be. Modulo? Truncate? Runtime error?
Build Wren for more targets, and run the test suite on both 32 and 64
bit builds.
* Update the build config to test both with and without NAN_TAGGING
defined.
* Updatest `util/test.py` to take the executable suffix as a
parameter. This allows the makefile to control which binaries will be
tested.
Adds a new target to the makefile to be run by travis, this runs the
test suite against all of the configurations it builds.
* Gcc on some 32 bit platforms was complaining about numeric overflows
when -INFINITY was used. Update the logic for converting a double to
a string to not explicitly check against the literal values.
* Make CI builds run the tests on both 64 _and_ 32 bit builds.
* If I limit the number of CPUs on my MBP I can get some of the tests
to time out, I'm imagining that the specs of the Travis Macs means
that the same is happening there too. Updated the test script to
allow an extra few seconds for the test to complete successfully
before killing it.
* Due to slight differences in accuracy in some computations tests were
failing on 32 bit builds. Stop comparing things quite as exactly in
the cases where it is causing issues.
For some reason 12.34 was refusing to compare equal to itself. Bad
show 12.34 :-/. I've also updated the test so it doesn't leak handles
even if the assertions fail.
* Double-cast from `double` to `uint32_t` to prevent undefined
behaviour on overflow of basic integers. This should hopefully
prevent 32 bit test failures on Linux.
* Move to a version of LibUV with a fix for the 32 bit build error on
Travis.
Get rid of the separate opt-in IO class and replace it with a core
System class.
- Remove wren_io.c, wren_io.h, and io.wren.
- Remove the flags that disable it.
- Remove the overloads for print() with different arity. (It was an
experiment, but I don't think it's that useful.)
- Remove IO.read(). That will reappear using libuv in the CLI at some
point.
- Remove IO.time. Doesn't seem to have been used.
- Update all of the tests, docs, etc.
I'm sorry for all the breakage this causes, but I think "System" is a
better name for this class (it makes it natural to add things like
"System.gc()") and frees up "IO" for referring to the CLI's IO module.
If a test expected an error and found at least one, it would not fail
on any other expected errors that didn't occur.
Also, some tests were expecting a compile time error message even though
the test script doesn't validate those (yet).
The test function was getting monolithic, so I went ahead and split it
into a separate little class.
